These tissue paper jellyfish are perfect for a mermaid birthday, under the sea party, or any other beachy event you might have!
My best friend Amy wanted to make some jellyfish for a Pirates and Mermaid’s event at her job. We decided to take my ever-popular tissue paper flowers and turn them into jellyfish with some crepe paper! So easy, so cute.
Start with two sheets of tissue paper, opened and flattened on a table. Don’t worry about creases — they’ll disappear as you make your…jellyfish top. I don’t know the parts of a jellyfish. Let me look it up…
Okay. So a jellyfish top is called the “bell” and the bottom is the “oral arms.” Perhaps we should just use top and bottom, because I’m not sure I want to rank highly in search engines for “oral arms.” o_O
Fold your tissue paper in half.
And in half again. You should have a square.
If you don’t have a square, fold into a triangle and trim of any excess. Then unfold your triangle so you have a square again.
Then take a look at your stack of paper. Two of the edges have folds. Using scissors or a rotary cutter and ruler, trim off the folded edges. Basically, you want to have eight even-ish squares of paper with no folds along the edges.
Accordion-fold your squares. I usually end up with six or seven folds.
Staple in the middle.
Trim the edge using an inward scallop. We decided this most looks like a jellyfish, though you have options.
Then fluff your jellyfish top. Start pulling the pieces of tissue paper upward, being careful not to rip them. Pulling them up from closer to the center helps prevent ripping, exactly the opposite of what this photo shows.
Fluff one side.
And then the other. Then you’re ready to work on the bottom!
Cut a few lengths of crepe paper. You can make them any length you want. We went long, because Amy is going to hang them from the ceiling.
Fold your crepe paper into a flat roll, about 3″ long.
Cut fringe onto both sides of your roll, making sure not to cut all the way across.
Then, before unrolling, fluff the fringe.
Then unroll, and fluff more, if desired.
Do this lots. We used seven crepe paper strands for each jellyfish.
Using craft glue, attach the crepe paper to the bottom of the jellyfish. We hung them using white thread, but piercing a threaded needle through the center of the jellyfish top and tying a knot.
TODAY’S TOP TEN POSTS
- How to Make Tissue Paper Flowers Four Ways 1,220 views
- 10+ DIY Dreamcatcher Tutorials 357 views
- Easy-Sew Two-Hand Casserole Pot Holder 197 views
- 5 Mistakes to Avoid While Painting Cabinets 184 views
- Shark Week: Corner Shark Bookmark 179 views
- The Best Meat Sauce Ever 162 views
- 12 Ways to Get the Fixer Upper Look at World Market 147 views
- How to Use the Cricut Tool Set 128 views
- Scottish Thistle QAYG Block 121 views
- Easy-Sew Curtains 110 views